Replacement Of Vulnerable Parts Of Nail Making Machine And Control Of Process

- Jan 01, 2020-

There are many components of the nail making machine, including many parts that are easily damaged. When these parts are worn or aged, the performance of the whole nail making machine will be reduced. Only replacing the new parts can solve this problem. .

In order not to affect the use of the nail making machine and the quality of the finished nail product, the cracked steel sleeve must be replaced first. If it is only dull, it needs to be removed and the front edge surface removed, and then installed You can go back and use it again. But if it cracks, you can only replace it with a new one.

There is also a wire roller that needs to be replaced. Long-term operation will wear the tooth shape, which will cause it to fail to roll out a qualified wire head. At this time, the thread rolling wheel needs to be replaced, and the washer for adjusting the pitch needs to be adjusted during the replacement, otherwise the nail making machine may not work normally.

The nail-making effect of the nail-making machine is directly related to the process equipment of the equipment itself. In order to ensure the quality of the nails, this aspect should also attract everyone's attention. The first is the fillet radius of the nail making machine, which is controlled to 1/20 to 1/5 of its diameter, which also helps the forging process of the nail.

The nail making machine also includes the upset head and flange parts, and its size and shape must be well controlled to avoid the problem of longitudinal bending of the nail. The nails are obtained by the extrusion equipment in the nail making equipment, so the size of the cross-sectional area of the extruded blank and the extruded part must be properly controlled to ensure one-time forming.

In this process, we also need to observe the change of the cross section of the extruded part, which mainly changes according to the properties of the material. The size tolerance of the nail making machine is as loose as possible, so as to ensure the normal operation of the nail making machine and the quality of the nails.